loading

China's leading brand of switching power solutions for power supply, power adapter and battery charger.

The power adapter charger fell in the water, can also be used?

When using the power adapter charger, accidentally fell in the water, don't know what will not be because there was water lead to unstable voltage or electrical damage your mobile phone? Actually we can through the following method to test and see what the charger can also use: 1, if it is the charger into the water, we can pick up the body shake sense of whether there is water inside, if there is water, can feel that prove it into a lot of water, impact on parts circuit will be big, it is difficult to completely dry. This time you can open it repaired as soon as possible, if not throw to buy the new one. 2, if the charger can't feel there is water, then how many there are saved. At this time of the charger can be made in the open air, with exposure under the sun or a lamp, a week or so, most of the water is running light. Then you can get cheap things of the old cell phone MP3 try once, can, that's no problem. 3 and pick it up with a hair dryer cold wind blow for a while, and then buried in a day of rice, because rice water imbibition is strong. Take out a day later, or to buy silicon chemical desiccant, further dehumidification. Note 2 days don't recharging or easily charge out of the question, if there are problems, it can only buy a again. Phone charger off water, dry can be used, but be sure to dry reoccupy, because if charging line with water, would be dangerous to use, if you don't know he do not dry, can hang a period of time and then use the reasons to make discharger is this: the design of the general electric is parallel to the direction and the direction of electric circuit board. That is to say if the shape of the electric equipment is flat, so the inside of the circuit board is flat on the inside, rarely with appliances and vertical shape. Mastery of the principles, we can use some good positions to fill the charger to dry. Because the charger circuit is simple, the area of circuit is small, can every few hours when drying is reversed direction, in order to speed up the water discharge. The charger with water if was soaked in use process, the relatively socket will be more dangerous. Especially sometimes can hear strip in edm flashing clicks, then this case never unarmed charger operation, should pull the strip after the plug or turn off the main supply room to operate.

GET IN TOUCH WITH Us
recommended articles
Info Center News FAQs
What is the difference between LED the RU and UL logo?

1059, 2020 -
05 -

13 09:30:48 for UL certification of different service types we often see different UL certification marks, usually UL marks can be divided into three categories: are UL Listed Listed, UL certification and accreditation Recognized and UL hierarchical Classification three different types of UL marks.
Common problems and solutions in the design of the LED power supply of 2020-986
07 -

01 16:29:37 in current life, in order to save energy, LED by large, but LED all need to have a power drive, it is good or bad will directly affect the service life of the LED, so how to make an LED driving power supply is the key of the LED power supply designer.
LED power supply overvoltage protection circuit is normally what effect is there?

1225, 2020 -
05 -

12 16:55:35 in LED power supply protection circuit design process, the setting of over-voltage protection circuit is essential, can effectively guarantee the normal operation of the whole power system.
LED waterproof power supply protection grade, introduced in 2020-1151
05 -

12 16:55:16 LED waterproof power supply protection grade introduce LED waterproof power supply protection grade abbreviations for IP (

国际保护)
It is thus by IEC (

国际电气技术委员会)

The draft, will prevent outside content invasion, waterproof, dustproof, moisture proof features and classification of a proper noun.
How do you use the USB charger, car charger, 2020-1023
05 -

21 10:53:49 along with the development of the automotive interconnect technology in recent years, mobile phone contact with car is more and more closely, it is also directly contributing to cell phone power consumption faster, so the car charger was born, and quickly spread to most of the owners.
In addition to the characteristics of PWM control itself, like working in a quasi resonant mode, light frequency, dynamic self-supply, low no-load power consumption characteristics, are similar to conventional flyback type circuit.
What is the LED driver power supply?
What is the feature of it?

2533, 2020 -
06 -

04 16:38:12 LED drive power is the power supply is converted into a certain voltage current to drive the LED power converter, normally: LED drive power supply input including high-voltage ac power frequency (
The mains)

Dc, high-voltage direct current, low voltage, low voltage high frequency ac (
Such as electronic transformer output)
And so on.
Why what is aging test, the power adapter do aging test?

1122, 2020 -
06 -

04 16:46:05 aging test, for consumer customers may be very unfamiliar words, then the power adapter manufacturer to simple to explain what is aging test, and why the power adapter do aging test?

Aging test is simple to show the power adapter is in a period of time full use work, to see what's the problem with the power adapter will produce.
Do you really understand what is a switching power supply?

1061, 2020 -
06 -

05 14:23:56 widely use of switching power supply, it is a important part of the electronic design, small, light weight, high efficiency is the key of the future development, how to do have to know what kind of switch power supply have characteristics.
What will you pay attention to when using the car charger, 2020-182
11 -

27 16:53:27, with the development of intelligent car is becoming more and more close contact phone, some cars even can support the direct manipulation of mobile phone.
Info Center
Contact Us
Copyright © 2026 Fuyuan Electronic Co.,Ltd. | Sitemap   | Privacy Policy
Customer service
detect